Skip to main content
Macro Items You can configure two items as part of the Macro: trigger a command or wait for {x} milliseconds. Selecting commands is the same as you know from other products in VRA. The wait time enables you to create a sequence with time in between triggers (for example for a fallback scenario; looping over two cameras. Conditions The macro’s can get really advanced by selecting conditions. These will enable or disable a item within the macro, so you can automate the full dynamic item list in the macro configuration. Block after Sometimes it is important to only continue triggering a section in the macro when a condition applies: “Only when music is playing, trigger the Nowplaying Clip Player, if not stop.” With Block After execution you can prevent the macro from continuation if a condition is not applicable.

​
Studio switching example

Below is one of the many scenario’s you can realise with Macro’s. When the following Macro is triggered, two actions are instantly executed:
  • Activate the selected studio (on air)
  • Set Overlay 1 to a specific Input in vMix